Search results for "Graphite furnace atomic absorption"
showing 9 items of 9 documents
Investigation of water sorption and aluminum releases from high viscosity and resin modified glass ionomer.
2019
Background High viscosity glass ionomer cement (HVGIC) and resin-modified glass ionomer cement (RMGIC) have recently been clinically preferred thanks to their numerous advantages. However, initial moisture contamination has a negative effect on the mechanical and physical properties of these cements. The aim of this study was in vitro of HVGICs and RMGICs, with and without surface protection, on water sorption, solubility and release of aluminum. Material and Methods In this study, as HVGICs; Equia Forte, IonoStar Plus, Riva Self Cure; as RMCIS, Ionolux and Riva Light Cure; and as control, Z250 universal composite was used. Equia coat, Voco varnish and Riva coat were chosen as surface prote…
Optimization of a GF-AAS method for lead testing in blood and urine: A useful tool in acute abdominal pain management in emergency.
2021
Suspicion of lead poisoning is confirmed by its concentration in blood and protoporphyrin red blood cells. At low concentrations, lead influences the synthesis of the heme in the sense of lowering it. Acute and chronic lead intoxication is extremely polymorphic in regards to its clinical manifestations, with digestive, hematological, cardiovascular, renal hepatic and neurological features. The aim of the study was to evaluate the presence of lead in human whole blood and urine harvested before and during chelation treatment in the case of lead poisoning. An atomic absorption spectroscopic method for the analysis of lead was developed using graphite furnace atomic absorption spectrophotomete…
Procedures of Separation and Pre‐concentration for Molybdenum Determination Using Atomic Spectrometry—a Review
2004
Abstract The literature concerning the improvement of atomic and ionic procedures for molybdenum determination through separation and pre‐concentration were updated. Analytical procedures based on flame atomic absorption spectrometry (AAAS), electrothermal or graphite furnace atomic absorption spectrometry (GFAAS), inductively coupled plasma optical emission spectrometry (ICP‐OES), and inductively coupled plasma mass spectrometry were reviewed taking into consideration the preliminary steps, which can enhance the selectivity and sensitivity based on co‐precipitation, solvent extraction, and solid‐phase extraction. Both in‐batch and on‐line procedures were considered.
GFAAS determination of selenium in infant formulas using a microwave digestion method.
1994
A method for determining the selenium content of infant formulas is proposed. It includes wet digestion with nitric acid and hydrogen peroxide in medium pressure teflon bombs in a microwave oven and determination by graphite furnace atomic absorption spectrometry (GFAAS). The absence of interferences is checked. Values obtained for the limit of detection (19.4 ng/g), precision (RSD = 2.2%) and accuracy by analysis of a reference material show that the method is reliable.
Oral intake of cadmium, cobalt, copper, iron, lead, nickel, manganese and zinc in the university student's diet.
1993
A duplicate diet meal study was carried out with a group of university students living in a hostel, in order to estimate the intake of Zn, Cd, Co, Cu, Fe, Mn, Ni and Pb. Zn, Cu, Fe, Mn and Ni were determined by flame atomic absorption spectrophotometry and Cd, Co and Pb by graphite furnace atomic absorption spectrophotometry after a nitric acid wet digestion procedure. The estimated intake values from the contents of breakfast, lunch, dinner and drinks were compared with the values of the Provisional Tolerable Daily Intake (PTDI) in the case of Cd and Pb, Recommended Dietary Allowances (RDA) of Co, Fe and Zn and Estimated Safe and Adequate Dietetic Daily Intake (ESADDI) of Cu and Mn. Neithe…
Detection of bias errors in ETAASDetermination of copper in beer and wine samples
2005
A method that evidences changes in the shape of the absorbance profiles obtained by graphite furnace atomic absorption spectrometry (ETAAS) is proposed. The method is based upon the apparent content curves model previously described for molecular spectroscopy and it permits the detection of possible sources of bias errors. Moreover, a procedure that allows to detect the existence of constant and/or proportional errors is also described. Both models has been applied to the determination of copper in wine and beer samples with and without pre-treatment of the samples. Results obtained evidence the usefulness of the proposed models.
Determination of lead on the airborne particulates of urban Valencia city
1991
A method for the determination of lead in airborne particulates by graphite furnace atomic absorption spectrometry after extraction with HCl-HNO3 (120–150°C) is described. Particulate lead levels in the atmosphere have been measured in samples collected throughout a year, sampling has been made at eleven sites within the city of Valencia. The results obtained in this study show that annual means of lead levels are within the range of 0.526 to 7.033 μg/m3 depending upon the sampling site. Lead levels are higher in winter and autumn. Lead and nitrogen oxide levels are well correlated.
Evaluation of Antimony, Cadmium and Lead Levels in Vegetables, Drinking and Raw Water from Different Agricultural Areas
1990
Abstract Lead and cadmium levels in edible vegetables and antimony, lead and cadmium in drinking and raw waters from three agricultural areas exposed to different levels of environmental pollution (1-high industrial pollution, 2-high urban pollution, 3-standard low industrial and urban pollution) are determined. The organic matter is destroyed by repeated attack with nitric acid. Cadmium and lead are determined by graphite furnace atomic absorption spectrometry (GFAAS) and antimony by hydride generation atomic absorption spectrometry (HGAAS). When the results obtained for three different areas are compared, differences between cadmium and lead contents in vegetables are observed. Waters are…
Some observations on the use of matrix modifiers in the determination of aluminum by electrothermal atomic absorption spectrophotometry
1989
Abstract Some evidence demonstrating that the use of matrix modifiers is necessary to obtain good calibration lines in the determination of aluminum by graphite furnace atomic absorption spectrophotometry is provided. It was found that the most sensitive results were obtained when Mg(NO 3 ) 2 was used instead of NH 4 H 2 PO 4 .